Home

Models, Books, and Shirts
Gifts For The Car Guy!
Share
Car Movies
Trans Am Parts
Car Television
FAQ
Links
Search Trans Am on Ebay
Magazines
About my '78 T/A
Books That I have Read
Rare Pontiacs
Tips & How To
Old Car Ads
Web Surfers Cars
Car Posters
Where to Buy/Sell your T/A
Gallery
Old Trader Ads
Other websites that I have created
Site map
My Photographs

 

How to Remove Your Automatic Transmission

To remove the automatic transmission from your car you will need a basic wrench set, socket set, jack stands, floor jack, and a transmission jack as pictured below.

Raise both the front and rear of your car and support it on good quality jack stands. 

Remove the linkage/cables for the shifter and throttle valve/kick down.

Remove the vacuum line for the modulator if so equipped.

Remove the rear u-joint from the rear end and slide the driveshaft/yoke from the transmission. Place a rag or an old yoke on the rear of the transmission to prevent fluid from coming out. 

Remove the speedometer gear assembly.

Place transmission jack under transmission pan and slightly  lift transmission.

Remove lower bell housing cover and remove torque converter bolts. 

Now remove bell housing bolts.

Next remove the 4 cross member bolts and the rear transmission mount.

Raise the transmission jack and remove cross member.

Roll the transmission jack to the rear of car while slowly lowering the transmission. Be sure to look and make certain that  the transmission is clearing everything and nothing is attached that should not be.

This is meant to be a general description on transmission removal. For more exact information consult a repair manual.

 

 

Northern Industrial Tools 1000-Lb. Capacity Transmission Jack Northern Industrial Tools 1000-Lb. Capacity Transmission Jack

"Safer, easier way to handle under-vehicle loads like transmissions and differentials. Allows smooth hydraulic lifting and lowering. Four adjustable load support arms swivel to fit objects. Head tilts 10° forward or backward and 10° to either side. Swivel casters roll easily. Safety chain included."


Pair of Jack Stands Pair of Jack Stands

Two heavy duty steel jack stands at one low price! Double locking pawl and tooth design for extra protection. Capacity: 3-ton Lift Range: 12in.-16in. Base: 7in. x 8in.


Northern Industrial Tools 2-Ton Floor Jack with Stands Northern Industrial Tools 2-Ton Floor Jack with Stands

Minimum height of 5 1/8 in. maximum height of 13 3/4 in. Two 2-ton angle steel jack stands included. 10 13/16 in. minimum height and 16 1/2 in. maximum height. Meets ANSI standards.


1998-2010

78blackbird@thepontiactransampage.com
Feel free to drop me a note. * I am looking for some good articles for the third and fourth gen birds. If you have any that you would like to see on this site send them to me and I will post them on my site.     

  • The information in here is just an outline.
  • The author claims no responsibility for the info contained in these pages. 
  • If unsure of any tip or modification seek a professional for the job.
  • In some states this may violate pollution laws
  • Check with your state on the laws.
  • Not affiliated with Pontiac or General Motors